An Apollo-era Communications Carrier Electronic Module(CCEM), Part No. 16495G-02, S/N 286. This module is the hardware component of the Communications Carrier Assembly, more commonly known as the ‘Snoopy Cap.’ It consists of earphones and microphones for both the right side and the left side. The two sides are joined with a 10.5″ wiring harness. In addition the right side has a wiring harness with a connector at the end for connecting to the spacecraft umbilical cable. The electronics for the earphones and microphones are contained within blue molded rubber enclosures, with molded recesses for the earphones. These rubber enclosures would be held in place over the astronaut's ears while wearing the ‘Snoopy Cap’. The wire harnesses are covered with Teflon fabric, which is the same fabric used for the ‘Snoopy Cap.’ In fine condition, with unit missing the right side microphone boom, and right side earphone rubber has been cut for a repair, and then sealed again. RRAuction COA.
Terms and abbreviations used in our descriptions.